Thursday, October 13, 2016

The Beast is no more.

Earlier this year I decided to resume work on the Beast. After removing the tarp  I discovered water damage and an infestation of carpenter ants.

The Beast has been dismantled, the ants swept up and fed to our two chickens.

Tuesday, July 21, 2009

Progress on the Beast



In the two photos posted here you can see my progress. 

In the first photo you can see the keel with a layer of fiberglass epoxy that still needs to be sanded you will also notice a long rectangular “hole” in the bottom of the boat were the dagger board will protrude (click to enlarge photo).

 



In the foreground of the next photo is the mast and beyond that 2 by 8 that I will hopefully transform into oars. 

 

Due to other obligations (I am also scraping and painting our house this summer) I will only be spending an hour or two every other day working on the Beast. Hopefully by August I will see if it floats.

Friday, June 19, 2009

Resurrecting the Beast

After a long winter's nap its time to resume my boat building project.

Sunday, February 8, 2009

Posting # 9


Work on the Beast is suspended until warmer weather.

Monday, November 17, 2008

Posting # 8 Topping off The Beast

The top deck curves slightly from port to starboard. This not only looks attractive but also allows water drain off. Standing water in a wooden boat, no matter what kind of wood or how it is treated, will promote rot. When the top deck is treated and sanded I will attempt to paint a fantastic mural on it’s surface inspired by the “paper cutout” that Matisse did in the 1950s called “The Beasts of the Sea” --- see posting #3.

Friday, November 7, 2008

Posting #7 The Beast is not a beauty --- yet




I am only spending an hour here and there so not much change in the Beast. I decided against constructing a double hull on the sides and I have re-designed the trunk. The trunk allows the dagger board to be forced down through bottom of the boat making it possible to sail. These changes should keep the boat light (under 120#).

I finished adding foam in the bottom, transom and the bow of the Beast. I sealed the transom by bending ¼ inch plywood from one side to the other adding a graceful curve to rear-in of the Beast. When the glue cures I will trim the edges with a handsaw.

Tuesday, October 28, 2008

Posting # 6 The Belly of the Beast


As you may have concluded I have decided on “Le Bete de la Mer” French for “The Beast of the Sea” as the name for my boat. I usually call it “The Beast”. I am working on the interior hull (the belly of the beast).


In the picture you can see Carmel, our dog, is sitting in the The Beast. I am using Styrofoam board between the exterior and interior hull. The Styrofoam will give it more floatation in case a tsaumi swamps The Beast. Behind Carmel is what is referred to as the “trunk” for the dagger board and mast.